Dual J-Head Raised Mount

Dual J-Head Raised Mount

Description

This Is The Dual Extrusion Version Of My Raised J-Head Mount. Same Pieces As Before: Main Mount, Front Piece And An Air Guide To Help The Fans Direct Air Towards The Peek Barrel. When Mounted, The J-Head Nozzles Should Be About 8Mm Below The X-Carriage Mounting Plate. (Enough Room For The Head Of The Mounting Bolt'S Head) I Have Printed This And Have It Installed. All The Measurements Look Good. I Added A 2Nd Version Of The Main, The Only Change Is I Shortened The Motor Supports Length To Allow More Room For The Wiring To Route Through The Rear.

Statistics

Likes

12

Downloads

0