Monster Acrylic Dice Tube - Conversion
Description
Convert New Or Broken Monster Acrylic Tubes Into Dice Holders And/Or Dice Tower; We Have Several Of These Tubes From Monster - Used To Hold Playmats; A Few Seem To Chip Or Crack On The Closed Ends After Being Dropped Or Shoved Precariously Into A Bookbag... Instead Of Throwing Them Out, We Converted A Few To Hold Dice And Use Them As Dice Tubes/Towers Using These Inserts. Depending On Wear/Tear You Will Need To Saw Off The Closed End Or Use A Hole Saw Drill Bit To Cut Out A Feeder Hole To Drop Your Dice In; Or Fall Out Depending On Your Preference. I'Ll Probably Rework This For Standard Circular Acrylic Tubes (2" Diameter) Note: I'Ve Had To Modify The Percentage Scale A Little Depending On Whether I Printed Them Using An Afinia Or A Rep2X; Ymmv I Printed The Two (Alternating) Single Units At 0.30Mm Height Taking About ~90 Minutes To Print... No Support Needed; Printed 6 And Slid Them Gently Into The Tube; No Glue Needed, Friction Held. I Have Not Printed The Alternating Units With The Mana Symbols Within Them Yet; That'S Lined Up For This Weekend. The Tube Rings Are Used To Slide Over The Acrylic Tube As 'Grips'; Careful Not To Snap Them When Sliding Over The Outside. Fee Free To Tinker Here: Https://Www.Tinkercad.Com/Things/Eyfz5Slyctl-Monster-Acrylic-Playmat-Tube-Dice-Tower-Single Https://Www.Tinkercad.Com/Things/Ercbcvyk9Xf-Monster-Acrylic-Playmat-Tube-Dice-Tower
Statistics
Likes
15
Downloads
0