Hanging Display and Arduino Ramps Mount for 25mm 8020 T-Slot Aluminum Extrusion Frame - LCD 12864 Graphic Smart Display Controller, Arduino Mega 2560, Ramps 1.4

Hanging Display and Arduino Ramps Mount for 25mm 8020 T-Slot Aluminum Extrusion Frame - LCD 12864 Graphic Smart Display Controller, Arduino Mega 2560, Ramps 1.4

Description

I took my previous designs for an [LCD mount](http://www.thingiverse.com/thing:1926631) and a [RAMPS mount](http://www.thingiverse.com/thing:1935626), both of which were angled 45deg and protruding from the top of my aluminum extrusion, and combined them into a single design which hangs down vertically from the top cross beam of my printer. I designed it so that there is clearance even on the rare occasions my X Axis is raised that high for a very tall print, your printer will vary so be sure to check this. I am including STEP files for this reason, so they will be easier to modify. Please link back and respect licensing requirements if you remix the design for your own needs. It is designed to fit the [LCD 12864 Graphic Smart Display Controller found here](http://amzn.to/2ldbuyR) and the standard Arduino Mega and RAMPS 1.4 printer controller setup. <b>Hardware Needed</b> - (4) M3x25 bolts with 4 M3 nuts and washers (to hold display front piece to back plate) - (3) M3x12 bolts with 3 M3 nuts and washers (to hold Arduino board to back plate) - (2) M6x12 bolts with 2 M6 washers and T-nuts (for attaching to Aluminum extrusion) <b>Notes</b> This is designed for 25mm extrusion. I have the bolts holding the electronics on the back as attaching to the Arduino. The RAMPS is then held to the Arduino naturally by the pins' friction. One of the bolt hole clearances is tight, I could not actually fit a washer in there. You could also use longer bolts on the back and run them through the RAMPS board if you wanted. <script src="//z-na.amazon-adsystem.com/widgets/onejs?MarketPlace=US&adInstanceId=330c4efd-c429-4176-9e2e-d3f4862f1d22"></script>

Statistics

Likes

34

Downloads

0