Solder and Wiring Jig Set

Solder and Wiring Jig Set

Description

This is a set of dies and holders to assist in soldering or terminating cables. There are two different Die holders that can be used in a variety of ways. I am looking at adding a clamping die for odd switches and connectors next. Ideally this should be used with a set of T-Track rails mounted 1.5" apart (Center to center), the knobs are designed to have a 1/4 nut inserted into them. The knobs would then thread onto 1/4" hex bolts inserted into the T-Track and through the two holes in the bases. 11/14/2017: Added Some Printable T-Track Bases, I have not tested these bases Yet. 11/14/2017: Added A Clamping Die set, the top clamp uses a press set 1/4-20 Nut, use with Knob_Clamp with a press fit 1/4x20 Hex Bolt. Added 8-32 and M4x0.7 versions 7/7/2018: Updated Base due to dimensional error, the T-track width sould now be the standard .48" Hope this helps everyone and please give suggestions for improvement. The Dies come in two versions, 8-32 tapped (Basic Name) and M4x0.7 (_M4).

Statistics

Likes

222

Downloads

0

Category

Hand Tools