Eachine PRO58 Fatshark Dominator HD3/HD2/HDO clip-on cover
Description
This is a cover for the Eachine PRO58 diversity module. The module goes into the cover, then the cover into the goggles. It has clips which will prevent it from falling out of your fatsharks while you fly. No tape needed! I designed this after printing a couple of cases already available. Whether because of module to module differences or just too tight tolerances/imprecision, none of them seemed to fit my goggles well enough. It took forever to make - almost a week and about 18 prints until it finally fits perfectly, so I'll really appreciate feedback if you decide to print one for yourself. I designed it for the Dominator HD3s, but it was also reported to fit HDOs (by [FiAsCoTeC](https://www.thingiverse.com/FiAsCoTeC/about)) and HD2s (by [phaseshift](https://www.thingiverse.com/phaseshift/about)) . If you want to remix this to fit other goggles, here's an Onshape link to the model: https://cad.onshape.com/documents/a2967962b5a508897639f347/w/459fd354f5bb73a3797ccf08/e/fb2a5abfa35e43e2f6d2cb4c This link is view/export-only. You need to register in onshape to copy.
Statistics
Likes
100
Downloads
0