Webcam (Logitech C270) Mount for Monoprice Select Mini 3d Printer
Description
Remixed to support a single part print for Logitech C270 webcam being mounted on Monoprice Select Mini. C270 is cheap and works great with Octoprint. This mount reuses the plastic pin and existing screw that comes with the camera. Simply pull off of the rubber covers on the hinge pin behind the camera. Unscrew the hinge pin and push it out using a small screwdriver (jeweler/glasses-repair size). Reuse hinge pin and screw to attach to the printed mount. The mount attaches to the bed in front of the bed rails as seen. On my mini the two holes were empty so I used 2 #4 machine screws and nuts to attach the mount. I have heard some versions have screws in those holes attached to the bed rail that can be reused. For the short distance from bed to camera mount you will probably want to pop off the cover of the C270, remove the screws to access the manual focus, and rotate the lens to focus better on the center of the bed plate - otherwise prints near the front of the bed plate will be out of focus. Takes a few minutes.
Statistics
Likes
21
Downloads
0