FlosStyle/ FlowRide GoPro Session Mount (15 Degree)
Description
This is a GoPro Session mount for the HyperLite FlosStyle / FlowRide Frame. I used my GoPro Session sleeve (found here: https://www.thingiverse.com/thing:2852274) and added the base. It has a 15 degree tilt and is mounted by using longer screws in the front standoffs and a short screw that goes through the rear of the case and top plate then held in place with a nut. I'm using a plastic (nylon) nut in hopes that it would break before the top plate in a bad crash. Please print this as it's shown in the render, no support are needed. This weighs 18 grams when printed with a 35% infill.
Statistics
Likes
15
Downloads
0