2-axis gimbal for mid-size camera
Description
I Made This Gimbal For My Canon A640, But It Can Easily Be Used For Other Camera Types. The Design Is Based On The Nex5 Gimbal From Nilsepils94 (Http://Www.Thingiverse.Com/Thing:248930) Total Print Volume Is 98 Cm3. To Complete The Gimbal You Will Need: 2X Quanum 4008 Brushless Motors 1X Controller Board, 2-Axis 1X Carbon Shock Absorbing Plate With Rubber Dampers 4X 16 Mm Alu. Tarot Tube Clamp 4X 12 Mm Tube Clamp ...Some Srews And Bolts Update: First Test With Sony Nex 5: Http://Youtu.Be/Yjy8Ndaokok Update 2015-02-15: I Had Problems With The Gimbal When Using It With The Heavier Sony Nex. Sad To Say I Replaced It With It A Dys Because Of Vibrations I Could Not Get Rid Of. Probably Because The Construction Is Not Stiff Enough And I Used Too Light Rubber Vibration Dampers. Update 2016-01-19: With Some More Experience With The Alexmos In Retrospect I Think The Vibrations Were Caused By Bad Pid Values Or Bad Connection Of The Imu Sensor. For Controller, A Stand Alone Nulled Version Alexmoss Controller Was Used Some Small Faults In The 3D Print Design: - Diameter Around Motors Of The Could Be 0.5 Mm Bigger (Tight Fit; Had To Use Aceton) - Cable Location Differ 90 Degrees On Some Quanum Motors; The Position Seems Not Consistant In Respect Of The Mounting Thread Holes The Design Was Printed With A Leapfrog, Without Support Material. More Footage: Http://Youtu.Be/Fselvdqglia (Stabilised) Https://Plus.Google.Com/Photos/108394968200012243536/Albums/6053086198104189761?Authkey=Ckemrr-C9Lfgaq
Statistics
Likes
163
Downloads
0