fishing rod holder selfie stick support
Description
This item was designed to be printed in flexible filament, hard plastics will not flex enough to allow it to be fitted. I recently converted a prima photo gear mono pod into a "selfie stick" to hold a 360degree camera when I was out kayak fishing. I noticed the hand grip fitted perfectly into the fishing rod holders on my crate. Unfortunately it wobbled quite badly as there was nothing to support the stick near the top of the rod holder. So I designed this "bung" to snugly hold it in place......wobble gone! Printed in generic flex filament, 0.2mm layer height, 15% infill.
Statistics
Likes
19
Downloads
0