ANYCUBIC Kossel Delta Filament Cooler (Fan Duct) REMIX
Description
I decided to make my own remix of this duct since I liked the ventilation the best out of all I've tested but every one I've printed very quickly started to melt and sag, which given the very sharp tips on the hanging end is also a big risk of snagging the print and breaking it free. This remix removes the 2 outermost holes making the whole thing a little bit shorter and rounding off the edges, as well as slimming the overall form down to match the sides of the effector plate. The inside diameter was also increased so that the duct is around 1mm further away from the hotend. I also added 2 more screw holes on the inside to make use of all 4 screws so there is very little chance of the vent hanging over time. Takes a little patience to get the screws in but you can access them through one of the vent holes directly above them and it fits very tightly and flat against the effector plate.
Statistics
Likes
49
Downloads
0