Melzi board cooler
Description
This is for Melzi printer boards, V1.0, 1.1, 1.2, and 2.0. There was only 1 model for the melzi 2.0 before and it would require me to bend some pins out of the way just to place on. This could be screwed down, but i prefer having it slot over the screw posts so I can rip it off without using a screw driver. It's designed to be used with M2.5 screws 15mm or greater in length for the 40mm fan mounts and M2.5 to m3 for the 4 mounting posts. It's reinforced around the fans.
Statistics
Likes
2
Downloads
0