ZMR 250 LowRider
Description
There is an updated Version available here: https://www.thingiverse.com/thing:3327180 Use bottomplates and arms from an old and used ZMR250 frame. Wanted to have the open sides to have an easy access to the electronics. Wanted to build something to throw around without hassle. Needs following screws: M3 30mm: 14-16 M3 7mm: 4 M3 10mm: 2 M3 nyloc-nuts: 18 M3 nut-standard: 2 One Bottom-plate needs to be cut out in front of the arms, to place the camera. I used an trusty old Runcam Skyplus with a magnesium-case of 30x30mm. Any big old FPV-Cam with 30x30mm-case will fit. Pins will hold the camera, I use two 7-10mm M3 to fix the angle of the camera. There is an alternative hood for a 25mm-FPV-camera. I used my cc3d-atom-enclosure to stack an Matek 5in1 and a cc3d-atom (https://www.thingiverse.com/thing:1684887). There is room enough for an 30.5x30.5 stack, RX in front, VTX in the back. What I like: Low profile, only 6 carbon parts, open sides to connect usb and check electronics. FPV-cam is fixed for rough use. What I don't like: When using all screws and locknuts for the arms it's a pain to remove the upper carbon to get a hand on the electronics.
Statistics
Likes
5
Downloads
0