Ultimaker Fan Shroud Repair
Description
<strong>This Item was printed in:</strong><a href="http://real-filament.com/">REAL-Filament's</a> Orange ABS ø2.85. <strong>Slicer:</strong> Ultimaker Cura 3.4.1. <strong>Somehow a part of the Original Ultimaker_2+ fan shroud broke off during a print, so I made a piece to fit the broken bit of the fanshroud. See pictures. </strong> <strong>Designed to fit in the original Ultimaker_2+ fanshroud. (See Pictures)</strong> <h3>Print Settings</h3> <strong>Quality</strong> Layer height: 0.20mm <strong>Shell</strong> Wall Thickness: 2mm Top/Bottom Thickness: 2mm <strong>Infill</strong> Infill Density: 30% Infill Pattern: Grid. Infill Overlap Percentage: 20% Skin Overlap Percentage: 20% <strong>Speed</strong> Print Speed: 70 mm/s. Travel Speed: 120 mm/s. <strong>Support</strong> Enable Support: No. <strong> Build plate Adhesion</strong> Build plate adhesion type: Brim. Brim Width: 8mm.
Statistics
Likes
4
Downloads
0