Anet A8/AM8 Titan with E3D V6 Direct Drive
Description
It's not experimental any more, it's functional and for now I don't see the need to improve it more, works very good. It was designed to be used with this carrier that works very good and very smooth better that IGUS and LM8UU bearings: https://www.thingiverse.com/thing:3031140 You should use this on the bed: https://www.thingiverse.com/thing:3039884 Note: I use a Tevo Titan, but it should work with original titan and clones. MARLIN Config: ============ X_PROBE_OFFSET_FROM_EXTRUDER 31 // X offset: -left +right [of the nozzle] Y_PROBE_OFFSET_FROM_EXTRUDER 0 // Y offset: -front +behind [the nozzle] Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle] // Travel limits (mm) after homing, corresponding to endstop positions. X_MIN_POS -13 Y_MIN_POS -7 Z_MIN_POS 0 UPDATES: ======== 12/08/2018 - 15:11 - The motor and titan support increased from 2mm to 2.4mm it's better to make both parts perfectly flat. 13/08/2018 - 09:14 - Hotend moved to the left to reach zero (In marlin switch is at -13)
Statistics
Likes
25
Downloads
0