Octopi Camera Arm and Mount for Heavy Duty Shelves
Description
This was my first attempt at using Fusion 360. It's not perfect, but it works for me. I printed it in Orange Hatchbox PLA using .10mm layer height on my Prusa. The arm is the only tricky part as it needs to be printed upright. You'll want to use a raft, but otherwise it does not need support. (Though, you could print it lying flat with support if you prefer.) None of the other parts need any support. I'm very happy with how the clip attaches to the shelf and could reuse this for others if I want to hang other things from the shelves. The ball that mounts to the shelf is pretty tight, so it might need a little more clearance if I print it again. It would be nice if the socket was turned at an angle or rotated, but this works. The mount in the picture has been given a drop of CA glue in each joint to keep it pointing in the right spot (at least until my preschooler decides he wants to touch it).
Statistics
Likes
12
Downloads
0