Flying Wing Tilting Nose
Description
When flying your FPV Wing ... did you ever just want to look down while you were cruising behind your mate and see what below in stead of just whats in front? Well now you can! This is a FPV Camera Tilting Mech for a Flying wing. remove your forward facing camera and mount cut out your Blunt section to fit the new cam mount and glue in place! This has a few pieces to be glued in place, there are 2 replaceable bumpers the main blunt mount then the cam/tilt mech. Note: If you nose dive into the road, rock, field, car or tree it will not save your camera! There is protection there for a light to rough landing. Best to print in PETG or ABS - PLA will warp in the sun. No the profile will not match every wings shape but it will be close I used a small sub 7-gram servo from hobbyking did a curl spring control rod so not to damage the servo if it tries to drive it into the housing. There is a hole in the back to pass through the cables from the cam and servo. Use VHB tape or simular to hold the cam in place, hot glue might release in flight? I also have a Pan & Tilt version but it protrudes too far in front and may get damaged on a not so elegant landing. The Wing in the picture is the "Fragile Handle with care" 46" Hazard RC wing i destroyed hence the packing tape which is now a feature :) My assembly with the hot glue was a little wild so it looks a little manky.
Statistics
Likes
9
Downloads
0