Keychain Phone Stand
Description
Keychain Phone Stand Remix. I just changed the design a bit. The original design is cool and so minimalist, because this stand is basically 2 small flat pieces that hangs on your key ring, and clicks together when you need it. Few notes: - There are 2 versions of the .stl file. 1 that is less slanted (holds your phone almost upright), and 1 that is more slanted back. Since there are so many types of phones and phone cases out there, you'll just have to see which works for you. - Takes about ~20 min. to print, and uses less than 1m filament. - You'll most likely have to sand the "male" piece just a tiny bit to get these to click together. Don't get all crazy, it only takes very little sanding before they click together. Obviously, you don't want them loose. Have fun!
Statistics
Likes
11
Downloads
0