RB1, RB3, RBB3 X Limit Switch End Stop - 3096
Description
This print's purpose is to give the X limit switch an end stop. Our Skip-Sense enabled RB3 and RBB3 printers already have a threaded hole on the X-Z rail, but the RB1 printers with a steel frames will need to have a hole drilled and tapped for an M4 bolt. The hole is in line with the rod connector on the other side. The rod connector can be used as a guide for locating the hole. If you use a 1/8" drill you can use an M4 bolt to self tap the hole. If printed with calibrated filament the bracket is tight enough to not need a bolt to hold it in place, but there is a hole in the bracket that can be used to secure it to the rail. I recommend one be used anyway. ---------- Part #3096 ---------- As with all our printer parts these are precision parts. For best results it is highly recommended that you use calibrated filament using the method found here: https://www.thingiverse.com/thing:1037301
Statistics
Likes
0
Downloads
0