Adafruit Crickit Holder Board No1
Description
This is a prototype mounting board for the Adafruit Crickit board. It is functional as-is, but we'll need to move the mounting holes a bit--you can put four (4) screws in, but the other four are shifted, because we weren't paying attention, it's it's not a completely symmetric design. The mounting posts/holes take an M3, I happened to use fairly short socket-heads, and they self-tapped surprisingly well. Keeps it off the table, you can set in on a pile of metal shavings now. There will be at least one additional version with an inset/lip for even easier grabbing, and possible one or two variations with mounting holes for the plate itself if you're so inclined. (There must be a good reason it's asymmetric, but it escapes us, and it makes building stuff for it that much more annoying. Boo hiss.)
Statistics
Likes
5
Downloads
0