Combined TalkTalk Huawei HG633 Router and shared HDD stand
Description
Bit of a niche one, this. I have a Huawei HG633 Router supplied by TalkTalk. It has the facility for a shared drive, so I have a nice little 2.5" USB HDD, with a very short cable, attached for my media. Trouble was that the drive never really sat comfortably. If I stood it up, it would invariably get knocked over. Flat on the table? it stayed put, but it would never sit square. This is my solution. The HDD goes in the slot, where it's held tightly by friction. The router sits in the top. Once put together, the router, stand, and HDD look like a single unit. Job's a good 'un! DRAWER VERSION: I did toy with the idea of having a couple of drawers each side of the HDD, but I eventually went with the solid structure as I felt drawers were a bit naff. I HAVE included the drawer design in the files, but note that it is untested, so you print at your own risk! As with the original, print with the HDD "tongue" vertical! FURTHER IDEA: A further thought occurred as I looked at it today. The angle of the router would make a lovely backboard for a phone stand. Just raise the top of the stand, whizz in a slot for a cable to pass through, and add a small lipped shelf for the phone to sit on, and Bob's your uncle.
Statistics
Likes
1
Downloads
0