Prusa i3 Laser Cut Frame and Braces - improved nut trap for PLY
Description
The frame designed by [Shane Graber](https://www.thingiverse.com/sgraber/about) is awesome (thx man) and I've been using it on a few build. However when using PLY instead of aluminium the nut trap is a bit weak and it will be the first place that give. So Using a [remix](https://www.thingiverse.com/thing:3060147) of the nut trap designed by [Joshua Rowley](https://www.thingiverse.com/joshuarowley42/about) from e3d I've modified the frame to allow the nut trap to fit in. Note: I've added the SLMS logo to the frame part of a group build I'm running when you setup in your job control just ignore (don't select those line part of the cut profile) The Fusion360 source is provided below. frame_6mm_ply_2.dxf is optimized to fit the cut into a 600x400 ply sheets the original arrangement was just a tiny bit outside the sheet.
Statistics
Likes
23
Downloads
0