Toucan Quad Spool Holder for Creality Cr10 Ender 3 Etc
Description
After discovering the incredibly popular Quad Spool Holder (22 Downloads and counting) had a slight flaw, where by the filament was forced over too tight an angle at the extruder, I decided to redesign the riser to overcome this without the need for extra parts. So for your filament dispensing needs, I present the Toucan spool holder, where I took inspiration from natures evolved lines and curves... something about birds.....aerodynamics? Basically, I definitely didn't just make the name up when I had almost finished because it looked a bit like a Toucan............or should I say Fourcan ...........because it uses four spools........no.........anyone. You will need: 1x Riser 1x Round Spool Holder 2x Square Spool Holders 4x Spool nuts (if you already have the dual holder its just 1x Riser 1x Round Spool Holder 1x Square Spool Holders 3x Spool nuts) A copy of the Creality nuts by Eckaat96 can be found here https://www.thingiverse.com/thing:2944665, but don't worry I have again included my big nut for you to download and play with. Fixings: 2x M4 x14 Machine Screw 2x M4 Rail (hammer head) Nut (I designed it around these as I had spare fixings with my Ender 3, hopefully you will too) Note: One nut is required as a back nut on the standard round spool holder, I have also included a round holder with a stop, negates the need for the nut but does need supports, so make your own mind up which you prefer. The filament guides are sized to take ptfe tube, the annoying bit inside the guide that makes it harder to pass the filament through is meant to be there as a stop for the ptfe tube to stop it being possibly pulled through, so remember when you try to push the filament through for the ninth time, its a feature :)
Statistics
Likes
66
Downloads
0