FrSky Taranis X-Lite Two-way switch extension
Description
Just got my X-Lite but found the 2-way switch, which I'd use for arming, was way too short for me to be comfortable with so I set about whipping up a quick extension. I could only find one other design for this but it was scaled very wrong, and had no instructions on what the correct scale should be. Print it in TPU or other flex filament. It has enough give to slip over the switch but stay put, whilst being rigid enough to make a solid switch. This is a dramatic improvement in my opinion. Still needs work as it's a bit sharp at the top, but this way it prints nicely with no support.
Statistics
Likes
67
Downloads
0