Phillips SHP-9500 Headphone cap
Description
A headphone cap I printed for my SHP-9500 headphones after I wanted to deaden the sound leak from the wire mesh. The sound stage and audio quality may slightly degrade but I noticed a significant drop in sound leakage after, so user satisfaction may vary. Installation is simple: -Remove the ear cups -Unscrew the 4 screws inside ear cup -Using a long thin object (screwdriver tip, rod, etc...), push the object into the screw holes popping the cap off (There are Youtube tutorials demonstrating this). -Remove the wire mesh on the cap and replace with the newly printed ones. -NOTE: Some sanding/ finishing my be required to get it to fit properly -You can use foam or other sound deadening substances to aid sound -Put the headset back together by reversing the above steps This is my second upload and would appreciate any feedback or ideas to improve upon the design, I will upload the source files if there is demand. NOTE: I am not responsible for any damages caused by improper modifications and this may void manufacturer warranty.
Statistics
Likes
0
Downloads
0