RAMPS adapter for Anet A8 (2016 version)
Description
This mount allows you to install RAMPS 1.4 board using the mounting holes from the stock controller board of an Anet A8 3D printer and the stock frame. Accesories: -3x M3 hex nuts -3x M3 nylock hex nuts -3x M3 washers -2x M3 socket head bolts (L=25mm) -2x M3 socket head bolts (L=25mm) -1x M3 socket head bolt (L=40mm) -3x M3 nylon PCB spacers (L=5mm). All the (three) hex recesses in the mount are meant to be used with regular hex nuts. The three holes which match with the frame hole pattern are meant to be secured with a washer and a nylock nut (tighten it carefully so you don't crack the frame). The M3x40 bolt is meant to be used in the "common" hole (top bottom corner of the picture). That means it needs a regular nut to hold RAMPS and also a nylock nut at the inner side of the frame to secure the whole assembly. Feel free to comment with any feedback, suggestion and/or issue!
Statistics
Likes
4
Downloads
0