Prusa I3 608ZZ Bearing Filiment Spool Holder
Description
Yes, I do aware there are thousands of different designs out there, based on my previous spool holder design, here's a version for Prusa I3, using 608zz bearing, fits spool size OD 200mm or up. There are only two overhangs need support, see photo, for a set of spool holder you will need: One Prusa_I3_608_Bearing_Filiment_Spool_Holder_Part1R One Prusa_I3_608_Bearing_Filiment_Spool_Holder_Part1L Two Prusa_I3_608_Bearing_Filiment_Spool_Holder_Part2 Four 608 ZZ Bearing Four M8-1.25 x 30mm Screw Four M8-1.25 Lock Nut 12 M8 Flat Washers Some super glue While using the spool holder, make sure the nut side is facing in, the two ledges are of different height. See the previous design here: 608ZZ Bearing Filiment Spool Holder with PTFE tube holder https://www.thingiverse.com/thing:3039579 All the fasteners are purchased from The Home Depot, 608ZZ bearing purchased from Amazon. layer height: 0.2mm Infill: 20% Infill type: Full Honeycomb Support: Yes Filiment type: PLA
Statistics
Likes
48
Downloads
0