Redcat Ramapage Snorkle
Description
<iframe width="560" height="315" src="https://www.youtube.com/embed/rH1fx5Qx378" frameborder="0" allow="autoplay; encrypted-media" allowfullscreen></iframe> This was a fun try at a snorkel! I had an inline foam block in a box I could clean. Weedeater type filter. Worked out fine but I found moving up the shell pillars and putting just the stock air filter unit on a second version worked easier! I can submerge my whole engine under water and it still runs! Both did! Version 2 Block is in another section! One shown in photos! Pla and petg worked fine for this build @100% infill water tight. 30mm id radiator hose was used in this build. With 2 zip ties. You can mount any filter system with stock hole patterns to my version 2! I like the fact its up high out of stuff* flying off tires into it and can go full motor under water run no worries! 120 to 1 gear ratio from motors to tires so kinda was intended as a mudding build And to actually make those stock tires no one likes really dig like they should :)
Statistics
Likes
0
Downloads
0