Filament mixer
Description
PLEASE MIRROR THE OBJECT! They will not line up perfectly if you print it twice! This is made for 10mm fittings for 1.8id and 4mm tubing for filament! I do not like the 4mm od / 2mm id because of its spring effect! Make sure your tubes are in the 2 mm slots where your top fitting go in. I used a small o ring to keep the bottom one center and flared it with a pair of crafting ring pliers. Be aware if you have a 20mm section of tubing you need it to retract another +20mm more to clear the extrusion area! 40mm retraction if you have a 20mm tube directly to your hotend like in a v5 v6 head! This is based on the Trigrilla Version! works with marlin 1.17 and up with any board that supports 2 or more heads!
Statistics
Likes
9
Downloads
0