Lemon Rx 6-Channel Receiver Case
Description
This is a two part case for the Lemon Rx 6-Channel Reciever (LM0027) I printed both parts with Hatchbox silver Pla on my Monoprice Select Mini. Part 2 needs supports. Once printed, I used a little ca glue to hold them together. Also, you may have to scale them up. When I imported them into cura it set the units as millimeters instead of inches. If you run into this problem too just scale up the 1.25mm side to 31.75mm. Happy printing!
Statistics
Likes
9
Downloads
0