Yi Ants cam 45 degrees angle mount
Description
I was in need of a 45 degrees mount in order to position my Yi Small Ants security cam outside, between a gate and a wall, so I decided to print it. The cam itself will tightly fit in the hole. You can also print the walls to better mount the cam steady but they're not totally necessary. Remember to use the support at least inside the hole. I printed with adesion layer in order to get also the bottom of the case nice and strong. Seal the mount with silicone in every border if using it outside. Also adding a fuse to prevent any short circuits could be useful. Don't worry, the top and bottom caps will snap perfectly, they're only extremely tight in order to prevent water from getting inside the case and damage the camera and the power supply. A 90 degrees flat usb cable must be used in order to close the bottom of the case.
Statistics
Likes
12
Downloads
0