Beat The Streak 2018 Trophy
Description
If you're running a Beat The Streak group, here's a trophy you can award the winner! The trophy is modelled after the official BTS logo, and is 10x10cm. It's 1.5cm deep, and sits in a recess in a plinth. It's a loose fit, so you may want to consider putting a little glue in the plinth to hold it if you think it needs it. Rotate the main trophy body 90 degrees on the X axis and print it flat. no idea why F360 exports it like that, it doesn't for any other project of mine... For best results, initiate a colour change on the main trophy at 10mm. In the photo I started with Prusa pearl green and swapped to Prusa white. The plinth reads "BEAT THE STREAK CHAMPION 2018" around the base
Statistics
Likes
2
Downloads
0