Holder Holder
Description
A stupid simple tape holder. Mount it horizontally on a wall/enclosure/whatever with the two pegs at the top. You can place rolls on top sitting on the two pegs, then hang even more rolls using the single bottom peg. This is meant to fit neatly on the leg of an Ikea Lack table/enclosure however it can of course be scaled bigger/wider/taller if needed. This is meant to be glued/taped on. If you want to drill it, then just print it at 100 percent and slow drill some pilot holes though and shoot a screw into it. For glue... using PLA, use Gorilla glue super control gel, if you ABS just use any plain old crazy glue/super glue.
Statistics
Likes
1
Downloads
0