Balance arm for Horus X10
Description
The Horus controller is big, and balances horribly when using a neck or shoulder strap. I needed a balancing arm that will be strong and will fit in the tight area around the small hook loop. This design is meant for my big Tarot shoulder strap hook and would not fit smaller hooks. Print black! :-) (just ran out ....) Printing: Use 0.15 layer height or less. Infill more then 60%. I used 80. Support over 70 degree and only under the arm. No support in the screw holes or the inner block Thread one hole M4 and drill the other 4mm.
Statistics
Likes
13
Downloads
0