Tail for Arduino
Description
A wagging tail. Print the tail top and tail bottom. Rubber cement one side to a flexible material, I used a shelf liner. Leave space between parts Cut out the material Rubber cement the other side lining up carefully Sew the edge holes I used a 3-doodler to reinforce some of the top holes Thread fishing line with high test through the top holes of both sides and secure at the end of the tail Thread the fishing line through the motor mount and the servo wheel. Secure the thread to the servo wheel with laces of fishing line Use the arduino file to wag the tail V2 uses less plastic and has reinforcement over the top holes
Statistics
Likes
6
Downloads
0