ZMR 250 Camera Tilt Mechanism
Description
This is a camera tilt mechanism for a ZMR 250 frame. I had to play around with various wall settings before I reached this third design. The main problem was I designed this before Cura had a "print walls smaller than [nozzle size]" but now that that is an option, I have included my earlier designs in case those work for you. Exact frame I used for this design has been discontinued. (Probably for the better, simply too outdated and there are better quad frames on the market now. I like the Transtec Frog Lite) Camera: https://www.banggood.com/Micro-13-CCD-600TVL-2_8mm-FPV-Mini-Camera-2525mm-For-FPV-Racer-p-1114003.html?rmmds=myorder&cur_warehouse=CN Servo: Any 9g servo should work. Note that you may have to cut part of the plastic mounting tabs off to make it fit. I cannot guarantee any of these designs will work for your quad. However, they use little filament so I would encourage you to try them out. The v3 worked for me but again I have included my earlier versions just in case.
Statistics
Likes
6
Downloads
0