Zip Tie Anchor Clip (Through-Body)
Description
**Now by popular demand: #8 and #10 versions** A simple clip that takes two #6 screws and has a curved cavity through which you can shove a zip tie easily. Most zip ties up to 30kg (70lb) size should work, the zip ties I use are 11" long and rated for 70lb and fit fine. The cavity is 2mm deep and 6mm wide - in practice you're not going to want to try and shove anything more than 1.5mm thick through it. I would imagine it's quite strong but I have no means of testing it's strength. Print it on it's back with no support. If you can't bridge 6mm, you should look [here](https://rigid.ink/blogs/news/how-to-print-overhangs-bridges-and-exceeding-the-45-rule) or [here](https://ultimaker.com/en/resources/19643-bridging) to be able to do this cleanly. I recommend printing at 0.1mm layer height; if you print at 0.2 you will further reduce the vertical clearance in the hole. Hole-to-hole spacing is 28.1mm (1.1"), and total width is 38.1mm (1-1/2" by design). *#8 Version: 42mm (a tiny bit under 1-5/8") total length* *#10 Version: 49.5mm (just a hair under 2") total length*
Statistics
Likes
621
Downloads
0