Spirit Halloween Ghostbusters Ecto Goggles Upgrade Parts
Description
Custom upgrade parts for the Spirit Halloween Ecto Goggles, based nearly wholly on crydrk's excellent GB2 Ecto Goggles. Requires forceful removal of the stock lenses. I twist them off with pliers. The lenses mount on the large bosses under the stock lenses. The cutout in the right lens is to allow the green LED to shine down the barrel of the lens, just like the stock lens. The snaps are scaled down from crydrk's original models, with mounting posts added. Twist off the 4 conical snaps on the left and right front edge of the frames, drill out the old posts with a 1/8" drill bit, and then install these in place of them. I've provided the bottomknob2 and middlecog file, scaled properly to millimeters from the original OBJ's, for attachment to your goggles. The bottomknob2 goes opposite the existing bottom knob, in roughly the same general location. The right lens should print without supports, but the left lens could use them. Similarly, the snaps will need support. Update 9/12/2018 - Updated the right lens model for better light distribution from the LED.
Statistics
Likes
36
Downloads
0