BlTouch Mount for CR10S
Description
# Info * There are **no additional parts needed** for installation. * The part is constructed according to the **height zero**. See also the drawing. * On the back are **omissions** for the cover of the Hotend. * **No plug is needed** to attach the cable to the mount. The cable can be soldered directly to the BLTouch. # My settings for Marlin Settings in _Configuration.h_ <pre> #define X_PROBE_OFFSET_FROM_EXTRUDER -38 // X offset: -left +right [of the nozzle] #define Y_PROBE_OFFSET_FROM_EXTRUDER -8 // Y offset: -front +behind [the nozzle] #define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle] </pre> Settings on the Printer Display after Testing: <pre> Prepare → Bed Leveling → Probe Z Offset : -00.60 </pre> _Please note that your settings may differ._ # Good Guid http://3dmakerita.it/2018/03/21/bltouch-on-cr10s-english-version-i-hope/ _When setting up the Marlin firmware, an additional guide should be used, because some features are missing in this guide._ # Help Uncomment <code>//G20/G21 Inch mode support</code> <code>#define INCH_MODE_SUPPORT</code> to avoid Errors with Serial-Printing-Software.
Statistics
Likes
106
Downloads
0