µDiva
Description
***This project requires a lot of close quarters building and soldering, it will probably be a bit frustrating to build so be aware *** These are the files for making the frame of the Micro Diva. It requires 7x regular brackets, and one of each of the other parts. There are two options for the back plate, one that has a hole for a 4 pin mini XLR, and one with no hole to give options for the USB wire. The face plate area surrounding the touch slider gets raster cut about 1-1.5mm deep to allow the touch slider to set into the face. the uDiva logo is also set in to be painted but that can be removed or changed if you would like. There are two brackets that need to be printed for holding the slider in place. You will also need the following parts to complete the build. 7X 1/4(6.35mm) buttons 4x Seimitsu PS-14-DN buttons of your color choice 1x Brook PS3/PS4 Fight Board PCBA 1x Brook Touch board (eBay usually has them, looks like the green PCB center top) 1x USB cable (4 pin mini XLR male and female optional) 1x Pack, M2 bolts 12mm 1x Pack, M2 bolts 8mm 1x Pack, M2 nuts
Statistics
Likes
12
Downloads
0