my hero academia - kirishima fantasy au daggers
Description
# kirishima's daggers from my hero academia's "fantasy au." modeled based on the (rather limited) pieces of official art. note that these are sized for a 6'1'' guy and measure ~26.5'' at default size, so some resizing may be necessary. **estimated print time:** ~13 hours (i suggest using a raft to ensure the seams are as flush as possible) **support:** there's a hole running through all the pieces big enough to snugly fit 3/8'' dowel, such as you might find at any old hardware store. **warning:** depending on your printer, the tolerance of the dowel hole can get pretty tight. if you can't work the dowel through the longer portions of the blade, a good alternative is to cut the dowel rod into sections and stick as much as you can into each piece of the sword. if you're planning to bring this to a con, make sure to sand the tip down, as it's painfully pointy fresh off the printer.
Statistics
Likes
107
Downloads
0