WFD100W Vase Mode Extension - Filament Drying
Description
After looking at the other extensions for the WFD100W and the estimated print time being over 5 hours I decided that was a bit ridiculous to me.These are designed to be printed in Vase mode with 0 bottom shells. Running a 0.6 volcano on my print with 0.2lh put me at about an hour and a half for ABS. A friend tested this out with an 0.4 nozzle at 0.2lh and was able to get them to print successfully but with a little bit of trouble. I would recommend using 0.6-1.0mm nozzle for printing this if possible. There are three variations uploaded (only the base variation tested but they should all work) Base: 80mm tall Double: 160mm tall Triple: 240mm tall This is for use with the Westinghouse WFD100W Dehydrator https://amzn.to/2xivZ5c You can leave the stock shelves intact or you can cut out the inner tray of all but one (for the bottom).
Statistics
Likes
11
Downloads
0