Clip/foot for CNC 20mm section frame
Description
I made this small clip as a support foot (with a rubber foot stuck underneath) for my 1610 CNC router, with two other corner feet to make a stable tri-point support. It could be useful too as a quick start for a project to mount something onto 20mm-section frames on any CNC machine. I've included the OpenSCAD file in case you need to modify it, or adapt it into your own project. So the model would be flexible enough to clip over the frame properly it's able to slide along the aluminium section. So, for my use as a foot, I put a piece of thin double sided tape in the bottom, which stops it sliding while not making it difficult to remove later. If you're interested, you can also read my blog-post about this project at the link below. https://cncmakerzone.co.uk/clip-for-20mm-extruded-section-frame
Statistics
Likes
20
Downloads
0