Tapping Wrench
Description
<strong>This Item was printed in:</strong><a href="http://real-filament.com/">REAL-Filament's</a> Natural (Clear) PLA ø1.75. <strong>Slicer:</strong> Slic3r Prusa Edition <strong>I had a tapping bit that did not fit the current tapping wrench I have so i made one to allow me use the bit. </strong> <h3>Print Settings</h3> <strong>Quality</strong> Layer height: 0.20mm <strong>Shell</strong> Perimeters: 7 Solid top layers: 7 Solid Bottom layers: 7 <strong>Infill</strong> Infill Density: 30% Infill Pattern: Honeycomb. Infill Overlap Percentage: 20% Skin Overlap Percentage: 20% <strong>Speed</strong> Print Speed: 70 mm/s. Travel Speed: 120 mm/s. <strong>Support</strong> Enable Support: No. <strong> Build plate Adhesion</strong> Build plate adhesion type: Brim. Brim Width: 6mm.
Statistics
Likes
28
Downloads
0