E3d Carriage Direct and Bowden for Anet A8, Prusa i3, Geeetech Modular
Description
This is A Carriage for the extruder, do you wan´t to try <b>bowden or direct?</b> Just fine! By simple unscrewing 2 screws you can change from direct to bowden! You want to <b>add 10mm</b> or even more to your printable height? Just try out! <h3><b>Why this is the best design?</b></h3> <ul> <li>It´s a Lightweight design</li> <li>Modular, you can change parts not used, or add different parts</li> <li>With only one screw you can change the height of Fan Duct</li> <li>It´s clean, your nozzle <b>will still be on your sight</b>, you can see what´s really happening</li> <li>It´s easy to maintenance, you don´t have to take out the fan duct if you wan´t to take out the hotend block</li> <li>You get a <b>bigger printable height</b>, I can get 260mm on stock Anet A8 (240mm) Frame</li> <li><b>Modular cable guide part</b>, so you can use standard cable layout</li> <li><b>Modular Chain</b> Support</li> <li>The motor will be <b>aligned to your vision</b>, so you can easily <b>pass the filament</b> or check for problems</li> <li>The extruder mount haves a <b>adjustable spring pressure</b> (can be adjusted by hand any time)</li> </ul> <br> <h3><b>The Dark Side :)</b></h3> <ul> <li>Can´t use standard fan duct (or compatible)</li> <li>You mostly use stock screws but you will need new ones like 2xM4x30mm to hold the Extruder</li> <li>You will need a small piece of PTFE Tube even for the direct</li> <li>You need a new End Stop Holder for the Z Axis, as you will gain more than 10mm (Link Below)</li> <ul/>
Statistics
Likes
83
Downloads
0