EEEkit Hygrometer (Humidity Sensor) Magnetic Mount
Description
**Be sure to view the print settings** as they explain how to insert the magnets during print! This is a magnetic mount for a [EEEkit Hygrometer](https://smile.amazon.com/gp/product/B07BLY177S/) (Amazon link, non-affiliate). You can use this to mount a humidity sensor anywhere a magnet will stick. You might also be interested in my [through-hole screw mount](https://www.thingiverse.com/thing:3097889) for this same hygrometer. You can easily snap the hygrometer into the "outer" casing; it'll hold tight as it has tabs on the inside. I printed the casing in PETG. The Fusion 360 `.f3d` is included in case you need to make any modifications. For this build, you'll need two 10x2mm neodymium magnets. They should be relatively heat tolerant if you're using a heated bed, otherwise you will see reduced performance of the magnet after the print!
Statistics
Likes
11
Downloads
0