Dremel Digilab Spool Adapter - 3D40 - 3D45
Description
4/6/20 - uploaded 3D40 versions with bigger spindle hole - not tested - based on other users measurements. Been testing the Dremel 3D45 and it's pretty good except for the specifically size hole and spindle for their filament spools. This adapter slides over the existing spindle allowing use of typical size spools. I've included a one-piece version that requires supports and a 2-piece version which prints without supports - simply glue support arm on (print v2 and support). I threaded the filament thru the bottom latch hole, around the bottom and up through the tube successfully.
Statistics
Likes
54
Downloads
0