Delta printer effector for NF-TC01 dual extruder Ver3
Description
I was not happy with the designs found here, so I made my own, to maximize the available print height. This supports the dual extruder named "NF TC-01", can be bought on aliexpress/ebay. To mount it, the extruder cables need to be bent at a steep angle, do at your own risk (mine works for more than half a year now). Also needs a few M3 screws. I recommend putting on a silicone sleeve on the hotend, as otherwise it might melt the nearby PLA (also best if printed in someting that is more heat resilient). The underside has some space for captive nuts to mount the push rods also with M3 screws. Supports two 40*10mm turbo fans, with built in fan shroud. A BLTouch is on the back side, with self tapping holes for again, M3 screws. The other version has another type of leveling sensor, a simple toggleable switch probe, that lays on the lever printed separately. Some 2 sided tape is required. Link: https://tinyurl.com/y4s6v4xo This proved to be much more accurate than the bltouch I had.
Statistics
Likes
7
Downloads
0