Mount for HomeMatic HM-OU-LED16 Status Display
Description
I liked the simplicity of https://www.thingiverse.com/thing:2788102 and the design of https://www.thingiverse.com/thing:2229345 but needed something a bit more sturdy to resist the utilization of the buttons on the back. The design should be printable without support and contain screw holes to mount it to my IKEA Ivar shelf. v0.8 was a basic fitting test but the sunken screw holes had the wrong angle (120°) and were not deep enoug. v0.9 is the design I am currently using but I disregarded an overhang so the inside looks a bit messy. v1.0 is the final design and should be printable in a perfect condition. The design should work with sunk screws up to 5mm. It features a **tight fit** so be aware you might get **scratches on the silver frame** of the status display when sliding in.
Statistics
Likes
11
Downloads
0