Stream Deck Mount
Description
>###NOTICE >I am not responsible for your use of this print, make sure it doesnt void your warranty, and make sure you are familiar with your printer. > >Any prints from me may require you to alter the scaling in your slicer depending on the shrink of the material/printer you are using. > >[www.iamfilth.com](http://iamfilth.com) This is a pretty basic mounting for the Elgato Streamdeck. You may have to play with the orientation of the legs and how you use supports to get it to print properly. I personally used support with an overhang of 75 degrees and printed with the flat connector piece down on the build plate. The main body screws to the legs with an M4 Screw and a matching nut and the screw is about 12 mm long but you could use something longer if you dont have one that sits flush. This mount has a screw hole on the flat connector piece because i was hard mounting it to a monitor riser i have on my desk but if you are planning to use it without mounting it as such you may want to use double-sided tape or something with grip on the bottom to prevent sliding.
Statistics
Likes
41
Downloads
0