P3Steel Y carriage belt holder
Description
Y carriage belt holder with Prusa MK3-style fixings. Very easy to change belts. No unnecessary tensioners - just loosen your P3Steel Y idler about 1-2mm, insert the belt, and tighten the Y idler. Dimensions are specifically measured, so that belt sits dead center and parallel with the 12mm diameter smooth idler and 16T motor pulley. Uses 2x M3 24mm + 2x M3 12mm screws with nylocks nut, assuming you have 3.3mm thick P3Steel frame. For best results, use: - 6 solid top/bottom layers - 6 perimeters - 0.48mm extrusion width (with single extrusion option enabled) - 30% rectilinear infill UPDATE: Added v2 version with a cutout, if you have a y carriage with two center bed screws.
Statistics
Likes
5
Downloads
0